F 19
F F6C.GB 19-30 0504
Diesel engine (17)
The engine oil level should be checked
with the dipstick (17.1) each time before
starting work.
Only check the oil level when the engine
is in a horizontal position!
$
An excessive oil level destroys the gas-
kets in the engine; insufficient oil causes
the engine to overheat and destroys it.
Refer to the engine operating instruc-
tions for oil and filter changes, fuel sys-
tem ventilation and valve play
adjustment
Check valve play and glow plugs
$
Check the engine’s valve play and glow
plugs after every 1000 hours of opera-
tion and adjust or replace if necessary.
To check and adjust valve play and to
check the glow plugs:
see engine operating instructions
Conveyor deflection rollers (20)
The deflection rollers for the conveyors
are lubricated with lubricating nipples
(20.1) located behind the crossbeam.
The centre bearings are lubricated via
the outer lubricating nipples.
V-belts (21)
When checking the V-belts, it must be
possible to push them inwards by max.
1–1.5 cm.
If this is not the case, tighten the V-belts
(see Motor-Betriebsanleitung).
Motoröl_F6.jpg
17.1
Valve.Tif
Lrostumlenk_F6C.jpg
20.1
21
Riemen_F6.jpg
To Next Page
Loading...
