F 1
F F6C.GB 1-30 0504
F Maintenance
1 Notes regarding safety
Maintenance work: Maintenance work may only be carried out when the engine is
at a standstill.
Secure the paver finisher and the attachments against inadvertent starting before be-
ginning any maintenance work:
- Set the drive lever to the centre position and the speed preselector to zero.
- Remove the traction drive fuse from the operating panel.
- Remove the ignition key and the main battery switch.
Lifting and jacking up: Secure lifted machine parts (e.g. screed or hopper) against
lowering by means of mechanical supports.
Spare parts: Use only approved parts and install them according to the specifica-
tions! If in doubt, contact the manufacturer!
Re-commissioning: Mount all protective devices before re-commissioning the paver
finisher.
Cleaning: Cleaning must not be carried out while the engine is running.
Do not use any inflammable substances (such as petrol).
Avoid directly cleaning electrical parts and insulation material with a steam jet; cover
them up beforehand.
Working in enclosed environments: Exhaust fumes must be conducted into the
open air. Propane gas bottles must not be stored in enclosed rooms.
$
In addition to these maintenance instructions, the maintenance instructions issued by
the engine manufacturer must be adhered to under all circumstances. All further
maintenance work and intervals listed in these are additionally binding.
To Next Page
Loading...
