Dynapac F6C - Driving Onto the Low-Bed Trailer; After Transportation

C 3
C_F6C_GB.fm 3-8 0504
2.2 Driving onto the low-bed trailer

Make sure that there are no persons in the danger area during loading.
- Use the work gear and low engine
speeds to drive onto the low-bed trail-
er.
- Lower the screed onto wooden blocks
on the low-bed trailer.
- Switch off the paver finisher.
- Attach and secure the protective hood
to protect the operating panel.
- If necessary, swing down the protec-
tive roof:
- Release the locking bolts (8) on both
sides of the suspension and fold the
roof down. When it is in the lower po-
sition, secure it again with the bolts
(8).
$
Do not insert fingers into the jointed are-
as! Danger of crushing!
- Secure the paver finisher to the low-
bed trailer:
- Use only appropriate, approved attachment devices.
- Use the four securing points provided
(13, 14).
- Wait until the exhaust extension tube
has cooled down; then remove it and
store it.
2.3 After transportation
- Remove the attachment devices.
- Swing up the protective roof, where applicable:
- Release the locking bolts, raise the protective roof and lock again.
- Lift the screed to the transportation position and lock it.
- Start the engine and drive from the trailer at a low engine/traction speed.
- Park the paver finisher in a secure spot, lower the screed and switch off the engine.
- Remove the key and/or cover the operating panel with the protective hood and se-
cure it.
Rampe_F6C.tif
Dachverrieg.jpg
8
DF65C.wmf
14
13