Dynapac F6C - Operating Elements on the Paver Finisher; Engine Speed Adjuster (67)

D 22
D F6C.GB 22-50 0504
2.3 Operating elements on the paver finisher
Engine speed adjuster (67)
The adjusting lever is located centrally
on the centre wall of the control panel.
Use this adjuster to set the desired en-
gine speed.
Setting:
- Pivot the lever up to increase the en-
gine speed.
- Pivot the lever down to reduce the en-
gine speed.
Under normal circumstances, the speed should be set to maximum during paving and
should be reduced for transportation!
Gas_F6.jpg
67