Dynapac F6C - Daily (or Every 10 Operating Hours)

F 3
F F6C.GB 3-30 0504
2.1 Daily (or every 10 operating hours)
$
Check the oil level twice a day during the run-in period of the diesel engine!
When work has been performed on the hydraulic system: check all filters after
20 operating hours and replace them where applicable!
Item Maintenance point
Quantity
Lubrication
Check
(Oil) change
Operating
material
Amount
4 Chain tension - conveyor 2 x
6
High-pressure hydraulic fil-
ter
(Number according to
equipment)
4/
5
x
8
Chain tension, conveyor
drive
2x
9 Auger - outer bearing 2 x Grease 5 squirts
17 Diesel engine - oil level 1 x Engine oil
20 Conveyor deflection roller 2 x Grease 5 squirts
22 Filling level, fuel tank 1 x Diesel fuel
see „Filling
volumes“
25
Hydraulic oil reservoir, fill-
ing level
1 x Hydraulic oil
see „Filling
volumes“
27 Chain tension - conveyor 2 x
General safety check: see section 3.1.
Safety check