D 13
D F6C.GB 13-50 0504
Item Designation Brief description
23
Auger
left/right
Astop: Off
B manual: feeding outwards
C auto: switched on with driver lever and Material limit
switch on the auger continuously controlled
D manual: feeding inwards
In positions (B) and (D), the auger half is running per-
manently (with full feed capacity, without automatic
material control).
If the auger is to be actuated automatically via the ultrasonic
sensor, both switches must be set to „auto“.
24
Adjustment of the
auger box
up/down (
&
)
This changes the height of the auger if the auger is hydrauli-
cally adjustable.
- The height can be read off on the scales to the left and the
right of the auger box.
Rule of thumb: paving thickness plus 5 cm (2 inches)
equals the auger height.
$
Actuate both switches at the same time as the auger
box otherwise pulls to one side!
25
Extend/retract
screed
In the case of variable screeds, the extendable parts can be
hydraulically extended/retracted with this switch.
26 Open/close hopper
Top: Close hopper halves
Centre: No function
Bottom: Open hopper halves
Separate actuation (
&
):
- One switch per hopper half:
Is required when paving in spaces where there is only limited
space at one side or when obstacles obstruct unloading of the
truck.
To Next Page
Loading...
