EDR-3000 IM02602003E
Name Description
ExP[4].Trip Signal: Trip
ExP[4].TripCmd Signal: Trip Command
ExP[4].ExBlo1-I Module Input State: External Blocking1
ExP[4].ExBlo2-I Module Input State: External Blocking2
ExP[4].ExBlo TripCmd-I Module Input State: External Blocking of the Trip Command
ExP[4].Alarm-I Module Input State: Alarm
ExP[4].Trip-I Module Input State: Trip
BF.Active Signal: Active
BF.ExBlo Signal: External Blocking
BF.Waiting for Trigger Waiting for Trigger
BF.Pickup Signal: BF-Module Started (Pickup)
BF.Trip Signal: Breaker Failure Trip
BF.Lockout Signal: Lockout
BF.Res Lockout Signal: Reset Lockout
BF.ExBlo1-I Module Input State: External Blocking1
BF.ExBlo2-I Module Input State: External Blocking2
BF.Trigger1-I Module Input: Trigger that will start the BF
BF.Trigger2-I Module Input: Trigger that will start the BF
BF.Trigger3-I Module Input: Trigger that will start the BF
TCM.Active Signal: Active
TCM.ExBlo Signal: External Blocking
TCM.Pickup Signal: Pickup Trip Circuit Supervision
TCM.Not Possible Not possible because no state indicator assigned to the breaker.
TCM.CinBkr-52a-I Module Input State: Feed-back signal of the Bkr (52a)
TCM.CinBkr-52b-I Module Input State: Feed-back signal of the Bkr. (52b)
TCM.ExBlo1-I Module Input State: External Blocking1
TCM.ExBlo2-I Module Input State: External Blocking2
CTS.Active Signal: Active
CTS.ExBlo Signal: External Blocking
CTS.Pickup Signal: Pickup Current Transformer Measuring Circuit Supervision
CTS.ExBlo1-I Module Input State: External Blocking1
CTS.ExBlo2-I Module Input State: External Blocking2
AR.Active Signal: Active
AR.ExBlo Signal: External Blocking
AR.Standby Signal: Standby
AR.t-Man Close Blo Signal: AR blocked after breaker was switched on manually. This timer will be started if the breaker was
switched on manually. While this timer is running, AR cannot be started.
www.eaton.com 718
To Next Page
Loading...
