Eaton EDR 3000 User Manual

EDR-3000 IM02602003E
System Module Input States
Name Description Assignment via
Ack LED-I Module Input State: LEDs Acknowledgment by Digital Input. [Device Para
/Ex Acknowledge]
Ack RO-I Module Input State: Acknowledgment of the Relay Outputs. [Device Para
/Ex Acknowledge]
Ack Comm-I Module Input State: Acknowledge Communication via Digital Input.
The replica that Communication has received from the device is to
be reset.
[Device Para
/Ex Acknowledge]
PS1-I State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
PS2-I State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
PS3-I State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
PS4-I State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
Maint Mode-I Module Input State: Arc Flash Reduction Maintenance Switch [Service
/Maint Mode]
System Module Signals
Signal Description
Reboot Signal: Rebooting the device: 1=Restart initiated by power supply; 2=Restart initiated by the User;
3=Set on defaults (Super Reset); 4=Restart by the debugger; 5=Restart because of configuration
change; 6=General failure; 7=Restart initiated by System Abort (host side); 8=Restart initiated by
watchdog timeout (host side); 9=Restart initiated by System Abort (dsp side); 10=Restart initiated
by watchdog timeout (dsp side); 11=Power supply failure (short term interruption) or power supply
voltage too low; 12=illegal memory access.
Act Set Signal: Active Parameter Set
PS 1 Signal: Parameter Set 1
PS 2 Signal: Parameter Set 2
PS 3 Signal: Parameter Set 3
PS 4 Signal: Parameter Set 4
PSS manual Signal: Manual switch over of a Parameter Set
PSS via Comm Signal: Parameter Set Switch via Communication
PSS via Inp fct Signal: Parameter Set Switch via Input Function
Min. 1 param changed Signal: At least one parameter has been changed
Program Mode Bypass Signal: Short-period bypass of the Program Mode.
www.eaton.com 265

Eaton EDR 3000 Specifications

General

Brand	Eaton
Model	EDR 3000
Category	Relays
Language	English