Edwards STP-iX457 Series - STP Pump Model Specifications

STP-iX457/iXU457 Series Turbomolecular Pump
MT-86E-001-F
Page 10
INTRODUCTION
1
1.8 STP pump specification
External appearance, installation and unpacking method differ depending to the STP pump
specification. Refer to the followings:
Standard type
(Without anticorrosion
treatment type)
Corrosion resistant type
STP-iX457/iXU457 STP-iX457C/iXU457C
Naming convention:
"C" following a pump model name indicates a corrosion resistant
*1
type.
(e.g. STP-iX457C)
"U" following a pump model name ”iX” indicates an low vibration specification with a built-in
damper. (e.g. STP-iXU457)
*1
Corrosion resistant: STP pump with anti-corrosive treatment.
The power supply unit iPS-240-24V is available as an optional accessory with the STP-iX457/iXU457
series. The power supply unit iPS-240-24V operates the STP pump, confirms the pump status and
sets various settings. (refer to Section 6.2 , the Instruction Manual of the "Display Unit iDT-001" and
“Power supply unit iPS-240-24V”.)
Power supply unit iPS-240-24V