EasyManua.ls Logo

Electrolux E23CS75DSS0 - Priming the Water Supply; To Prime the Water Supply System; Ice Maker Operation & Care; Using the Ice Maker after Installation

Electrolux E23CS75DSS0
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
Section B - Refrigerator Cabinet
Priming the water supply
system
Yourrefrigerator’swatersupplysystemincludes
severaltubinglines,anadvancedwaterlter,
adistributionvalvebank,andareservetankto
ensureamplesupplytotheiceandwaterdispenser
atalltimes.Thissystemneedstobecompletely
lledwithwaterwhenrstconnectedtoanexternal
supplyline.
To prime the water supply system:
1 Beginllingthetankbypressingandholding
adrinkingglassagainstthewaterdispenser
paddle.
2 Keeptheglassinthispositionuntilwater
comesoutofthedispenser.It may take
about 1½ minutes.
3 Continuedispensingwaterforaboutthree
minutestoushthesystemandplumbing
connectionsofanyimpurities(stoppingto
emptytheglassasnecessary).
Ice maker operation & care
Theicemaker,icebin,anddispenserfeeding
mechanismarelocatedinthetopofthefreezer
compartment.Aftertherefrigeratorisinstalled
properlyandhascooledforseveralhours,the
icemakercanproduceicewithin24hours.Itcan
completelyllanicebininabouttwodays.
Theicemakerproducesfourtosixpoundsofice
every24hoursdependingonusageconditions.Ice
isproducedatarateofeightcubesevery75to90
minutes.
Using the ice maker after installation
Beforemakingiceforthersttime,besureto
primethewatersupplysystem.Airinnewplumbing
linescanresultintwoorthreeemptyicemaker
cycles.Furthermore,ifthesystemisnotushed,
thersticecubesmaybediscoloredorhavean
oddavor.
Turning the ice maker on and off
Iceproductioniscontrolledbytheicemaker’sOn/
Offpowerswitch.Togainaccesstotheicemaker,
pulltheextrashelfout(somemodels).Pressthe
switchtothe“OpositiontoturnitOffandpressto
theI”positiontoturnitOn.
OFF
ON
OR
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30 psi and 100 psi.
Excessive pressure may cause water filter to
malfunction.
NOTE
Thewaterdispenserhasabuilt-indevicethat
shutsoffthewaterowafterthreeminutesof
continuoususe.Toresetthisshutoffdevice,
simplyreleasethedispenserpaddle.
IMPORTANT
Theicemakeristurnedonatthefactorysoitcan
workassoonasyouinstallyourrefrigerator.If
youcannotconnectawatersupply,turntheice
maker’sOn/OffswitchtoOff.Otherwise,theice
maker’sllvalvemaybenoisywhenitattemptsto
operatewithoutwater.
NOTE
Theicemakeralsohasabuilt-inwiresignalarm,
whichautomaticallystopsiceproductionwhen
theicebinisfull.Thissignalarmshouldnotbe
usedtomanuallystoptheicemaker.

Table of Contents

Related product manuals