Release date: 01 Nov 2021
Revision: 1.0
•
•
Press Send to immediately send waypoints to the mission.
Press Pause to pause the mission.
As waypoints are achieved by the drone, they are removed from view on the real-time display. The
remaining waypoints will move to the left in the Waypoint Manager. Once all waypoints have been
achieved, the drone will hover and the status will show as idle while it waits for a new command.
However, if Wi-Fi communications are lost when the last waypoint is achieved, Hovermap will trigger
the Wi-Fi Communications Loss RTH failsafe. Refer to the Emergency Procedures section for more
information.
Note
Waypoints can only be sent once the drone has taken off.
To Next Page
Loading...