Release date: 01 Nov 2021
Revision: 1.0
•
•
•
•
•
1.
2.
3.
4.
5.
6.
7.
4.1.2.1 Set up Hovermap-Zoe
Required equipment
You should have the following equipment for Hovermap-Zoe operation:
Zoe drone
Controller
Controller batteries: Check the screen to make sure that these are fully charged
Hovermap and associated equipment
Flight batteries: Check the inbuilt battery monitors to make sure that these are fully charged
Step 1: Assemble Zoe
Lift the Zoe center frame out of the case.
Install and secure the legs to the body of the Zoe.
Ensure that any cables are securely connected and fully pushed home.
Stand the Zoe on its legs.
Install the batteries.
Unfold the propellers so that they are completely extended.
Make sure the antennas are facing downwards, away from obstructions, to avoid loss of control
due to signal loss.
Note
The screen gives a voltage, not a percentage. Fully charged is 8.4 V. Do not start a
flight if the voltage is less than 7.2 V.
Caution
If you position the antennas horizontally, the Zoe propellers may collide with
them. Please position them carefully in order to avoid this.
To Next Page
Loading...