Cerabar M PMC51, PMP51, PMP55
126 Endress+Hauser
Level
If the option "K" was selected for the order code for "Calibration; Unit" in the Product Configurator, the
following configuration data sheet must be completed and included with the order.
Pressure unit Output unit (scaled unit)
Mass Lengths Volume Volume Percent
mbar
bar
psi
mmH
2
O
mH
2
O
ftH
2
O
inH
2
O
mmHg
kgf/cm
2
Pa
kPa
MPa
kg
t
lb
m
dm
cm
mm
ft
inch
l
hl
m
3
ft
3
in
3
gal
Igal
%
Example
A0024007
A 0 mbar / 0m
B 300 mbar (4.5 psi) /
3 m (9.8 ft)
Empty pressure [a]:
Low pressure value (empty)
___________
[Pressure
engineering unit]
Empty calibration
[a]:
Low level value
(empty)
___________
[Scaled unit]
Full pressure [b]:
High pressure value (full)
___________
[Pressure
engineering unit]
Full calibration [b]:
High level value
(full)
___________
[Scaled unit]
Display
1st Value Display
1)
2nd Value Display
Main Value
None (Default)
Main Value [%]
Pressure
Current [mA] (HART only)
Temperature
1) Depending on sensor and communication version
Damping
Damping: ___________ sec (Default 2 sec)
To Next Page
Loading...
