Endress+Hauser HART Proline t-mass I 300 - Turning the Display Module

Proline t-mass I 300 HART Installation
Endress+Hauser 31
1.
2.
3.
4 mm
7 Nm (5.2 lbf !)
A
A
A0043150
 18 Ex housing
1. Release the fixing screws.
2. Turn the housing to the desired position.
3. Tighten the securing screws.
5.2.5 Turning the display module
The display module can be turned to optimize display readability and operability.
N
i
c
h
t
u
n
t
e
r
a
r
e
ö
f
f
n
e
n
+
E
ESC
–
1.
2.
N
i
c
h
t
u
n
t
e
r
a
r
e
ö
f
f
n
e
n
+
E
ESC
–
3.
3 mm
+
E
ESC
–
A0030035
1. Depending on the device version: Loosen the securing clamp of the connection
compartment cover.
2. Unscrew the connection compartment cover.
3. Turn the display module to the desired position: max. 8 × 45° in each direction.
4. Screw on the connection compartment cover.
5. Depending on the device version: Attach the securing clamp of the connection
compartment cover.