Endress+Hauser HART Proline t-mass I 300 - Function Scope of the Configuration Management Parameter; Simulation

Commissioning Proline t-mass I 300 HART
120 Endress+Hauser
9.6.1 Function scope of the "Configuration management" parameter
Options Description
Cancel No action is executed and the user exits the parameter.
Execute backup A backup copy of the current device configuration is saved from the HistoROM
backup to the memory of the device. The backup copy includes the transmitter data
of the device.
Restore The last backup copy of the device configuration is restored from the device
memory to the device's HistoROM backup. The backup copy includes the
transmitter data of the device.
Compare The device configuration saved in the device memory is compared with the current
device configuration of the HistoROM backup.
Clear backup data The backup copy of the device configuration is deleted from the memory of the
device.
HistoROM backup
A HistoROM is a "non-volatile" device memory in the form of an EEPROM.
While this action is in progress, the configuration cannot be edited via the local
display and a message on the processing status appears on the display.
9.7 Simulation
The Simulation submenu enables you to simulate, without a real flow situation, various
process variables in the process and the device alarm mode and to verify downstream
signal chains (switching valves or closed-control loops).
Navigation
"Diagnostics" menu → Simulation
‣
Simulation
Assign simulation process variable
→  121
Process variable value
→  121
Current input 1 to n simulation
→  121
Value current input 1 to n
→  121
Status input simulation 1 to n
→  121
Input signal level 1 to n
→  121
Current output 1 to n simulation
→  121
Value current output 1 to n
→  121
Frequency output simulation 1 to n
→  121
Frequency value 1 to n
→  121