Endress+Hauser HART Proline t-mass I 300 - Process

Technical data Proline t-mass I 300 HART
180 Endress+Hauser
15.9 Process
Medium temperature range Sensor
–40 to +180 °C (–40 to +356 °F)
Seals
• Sealing rings:
• EPDM –40 to +140 °C (–40 to +284 °F)
• FKM –40 to +180 °C (–40 to +356 °F)
• Ferrule:
• PEEK –40 to +140 °C (–40 to +284 °F)
• PVDF –20 to +110 °C (–4 to +230 °F)
• 1.4404 –40 to +180 °C (–40 to +356 °F)
Ferrule in 1.4404: ferrule has a fixed position on the shaft. Restriction for repeat
calibrations (observe minimum insertion depth →  20)
Medium pressure range Minimum 0.5 bar absolute. Maximum permitted medium pressure →  180
Pressure/temperature
ratings
The following pressure/temperature diagrams apply to all pressure-bearing parts of the
device and not just the process connection. The diagrams show the maximum permissible
medium pressure depending on the specific medium temperature.
Ferrule
PEEK
1.4404
-80
0 80 160
240
320 400
0
10
20
30
40
0
200
400
600
[°C]
[°F]
[bar][psi]
20015010050
0
-50
50
A0041035-EN
 44 With compression fitting material 1.4404/F316L/F316
PVDF
-80
0 80 160
240
320 400
0
10
20
30
0
200
400
[°C]
[°F]
[bar][psi]
20015010050
0
-50
A0041590-EN
 45 With compression fitting material 1.4404/F316L/F316
Flow limit Measuring range →  164