Endress+Hauser HART Proline t-mass I 300 - Displaying the I;O Configuration

Proline t-mass I 300 HART Commissioning
Endress+Hauser 87
Parameter Description Selection Factory setting
Temperature unit Select temperature unit. Unit choose list Country-specific:
• °C
• °F
Pressure unit Select process pressure unit. Unit choose list Country-specific:
• bar a
• psi a
Velocity unit Select velocity unit. Unit choose list Country-specific:
• m/s
• ft/s
Length unit Select length unit for nominal diameter. Unit choose list Country-specific:
• mm
• in
Date/time format Select date and time format. • dd.mm.yy hh:mm
• dd.mm.yy hh:mm am/pm
• mm/dd/yy hh:mm
• mm/dd/yy hh:mm am/pm
–
9.4.7 Displaying the I/O configuration
The I/O configuration submenu guides the user systematically through all the parameters
in which the configuration of the I/O modules is displayed.
Navigation
"Setup" menu → I/O configuration
‣
I/O configuration
I/O module 1 to n terminal numbers
→  87
I/O module 1 to n information
→  87
I/O module 1 to n type
→  88
Apply I/O configuration
→  88
I/O alteration code
→  88
Parameter overview with brief description
Parameter Description User interface / Selection / User entry
I/O module 1 to n terminal numbers Shows the terminal numbers used by the I/O module. • Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
I/O module 1 to n information Shows information of the plugged I/O module. • Not plugged
• Invalid
• Not configurable
• Configurable
• HART