Endress+Hauser HART Proline t-mass I 300 - Configuration management

Commissioning Proline t-mass I 300 HART
110 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Connection state – Displays the connection status. • Connected
• Not connected
–
Received signal strength – Shows the received signal
strength.
• Low
• Medium
• High
–
* Visibility depends on order options or device settings
9.5.5 Configuration management
After commissioning, you can save the current device configurationor restore the previous
device configuration.
You can do so using the Configuration management parameter and the related options
found in the Configuration backup submenu.
Navigation
"Setup" menu → Advanced setup → Configuration backup
‣
Configuration backup
Operating time
→  110
Last backup
→  110
Configuration management
→  110
Backup state
→  111
Comparison result
→  111
Parameter overview with brief description
Parameter Description User interface / Selection
Operating time Indicates how long the device has been in operation. Days (d), hours (h), minutes (m) and seconds
(s)
Last backup Shows when the last data backup was saved to HistoROM
backup.
Days (d), hours (h), minutes (m) and seconds
(s)
Configuration management Select action for managing the device data in the HistoROM
backup.
• Cancel
• Execute backup
• Restore
*
• Compare
*
• Clear backup data