Endress+Hauser HART Proline t-mass I 300 - Configuring the current input

Commissioning Proline t-mass I 300 HART
88 Endress+Hauser
Parameter Description User interface / Selection / User entry
I/O module 1 to n type Shows the I/O module type. • Off
• Current output
*
• Current input
*
• Status input
*
• Pulse/frequency/switch output
*
• Relay output
*
Apply I/O configuration Apply parameterization of the freely configurable I/O module. • No
• Yes
I/O alteration code Enter the code in order to change the I/O configuration. Positive integer
* Visibility depends on order options or device settings
9.4.8 Configuring the current input
The "Current input" wizard guides the user systematically through all the parameters that
have to be set for configuring the current input.
Navigation
"Setup" menu → Current input
‣
Current input 1 to n
Current span
→  89
Terminal number
→  89
Signal mode
→  89
Terminal number
→  89
0/4 mA value
→  89
20 mA value
→  89
Failure mode
→  89
Terminal number
→  89
Failure value
→  89
Terminal number
→  89