Endress+Hauser HART Proline t-mass I 300 - Adapting the Measuring Device to the Process; Conditions; Performing a Totalizer Reset

Proline t-mass I 300 HART Operation
Endress+Hauser 131
Parameter overview with brief description
Parameter Description User interface
Switch status Shows the current relay switch status. • Open
• Closed
Switch cycles Shows number of all performed switch cycles. Positive integer
Max. switch cycles number Shows the maximal number of guaranteed switch cycles. Positive integer
10.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using theSetup menu (→  77)
• Advanced settings using theAdvanced setup submenu (→  103)
10.6 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers
Navigation
"Operation" menu → Totalizer handling
‣
Totalizer handling
Control Totalizer 1 to n
→  131
Preset value 1 to n
→  131
Reset all totalizers
→  131
Parameter overview with brief description
Parameter Prerequisite Description Selection / User entry
Control Totalizer 1 to n A process variable is selected in the
Assign process variable parameter
(→  104) of the Totalizer 1 to n
submenu.
Control totalizer value. • Totalize
• Reset + hold
• Preset + hold
• Reset + totalize
• Preset + totalize
• Hold
Preset value 1 to n A process variable is selected in the
Assign process variable parameter
(→  104) of the Totalizer 1 to n
submenu.
Specify start value for totalizer.
Dependency

The unit of the selected process
variable is specified for the
totalizer in the Unit totalizer
parameter (→  104).
Signed floating-point
number
Reset all totalizers – Reset all totalizers to 0 and start. • Cancel
• Reset + totalize