Endress+Hauser HART Proline t-mass I 300 - Page 130

Operation Proline t-mass I 300 HART
130 Endress+Hauser
Parameter overview with brief description
Parameter Description User interface
Output current 1 Displays the current value currently calculated for the current
output.
3.59 to 22.5 mA
Measured current Displays the current value currently measured for the current
output.
0 to 30 mA
Output values for pulse/frequency/switch output
The Pulse/frequency/switch output 1 to n submenu contains all the parameters needed
to display the current measured values for every pulse/frequency/switch output.
Navigation
"Diagnostics" menu → Measured values → Output values → Pulse/frequency/switch output
1 to n
‣
Pulse/frequency/switch output
1 to n
Output frequency 1 to n
→  130
Pulse output 1 to n
→  130
Switch status 1 to n
→  130
Parameter overview with brief description
Parameter Prerequisite Description User interface
Output frequency 1 to n In the Operating mode parameter, the
Frequency option is selected.
Displays the value currently measured
for the frequency output.
0.0 to 12 500.0 Hz
Pulse output 1 to n The Pulse option is selected in the
Operating mode parameter parameter.
Displays the pulse frequency currently
output.
Positive floating-point
number
Switch status 1 to n The Switch option is selected in the
Operating mode parameter.
Displays the current switch output
status.
• Open
• Closed
Output values for relay output
The Relay output 1 to n submenu contains all the parameters needed to display the
current measured values for every relay output.
Navigation
"Diagnostics" menu → Measured values → Output values → Relay output 1 to n
‣
Relay output 1 to n
Switch status
→  131
Switch cycles
→  131
Max. switch cycles number
→  131