Endress+Hauser HART Proline t-mass I 300 - Configuring the measurement mode

Commissioning Proline t-mass I 300 HART
78 Endress+Hauser
‣
Pulse/frequency/switch output
1 to n
→  92
‣
Relay output 1 to n
→  98
‣
Display
→  99
‣
Low flow cut off
→  102
‣
Advanced setup
→  103
9.4.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
1
XXXXXXXXX
A0029422
 39 Header of the operational display with tag name
1 Tag name
Enter the tag name in the "FieldCare" operating tool →  70
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry
Device tag Enter the name for the measuring point. Max. 32 characters, such as letters, numbers
or special characters (e.g. @, %, /).
9.4.2 Configuring the measurement mode
Properties of the medium can be configured in the Measurement mode submenu.
Navigation
"Setup" menu → Measurement mode
‣
Measurement mode
Measurement application
→  80
Select gas type
→  80