Endress+Hauser HART Proline t-mass I 300 - Configuring the Relay Output

Commissioning Proline t-mass I 300 HART
98 Endress+Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Switch-off delay • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Define delay for the switch-off
of status output.
0.0 to 100.0 s –
Failure mode – Define output behavior in
alarm condition.
• Actual status
• Open
• Closed
–
* Visibility depends on order options or device settings
9.4.11 Configuring the relay output
The Relay output wizard guides the user systematically through all the parameters that
have to be set for configuring the relay output.
Navigation
"Setup" menu → Relay output 1 to n
‣
Relay output 1 to n
Terminal number
→  99
Relay output function
→  99
Assign limit
→  99
Assign diagnostic behavior
→  99
Assign status
→  99
Switch-off value
→  99
Switch-off delay
→  99
Switch-on value
→  99
Switch-on delay
→  99
Failure mode
→  99