Endress+Hauser HART Proline t-mass I 300 - Configuring the Pulse;Frequency; Switch Output

Commissioning Proline t-mass I 300 HART
92 Endress+Hauser
9.4.10 Configuring the pulse/frequency/switch output
The Pulse/frequency/switch output wizard guides you systematically through all the
parameters that can be set for configuring the selected output type.
Navigation
"Setup" menu → Advanced setup → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  92
Parameter overview with brief description
Parameter Description Selection
Operating mode Define the output as a pulse, frequency or switch output. • Pulse
• Frequency
• Switch
Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  93
Terminal number
→  93
Signal mode
→  93
Assign pulse output
→  93
Pulse scaling
→  93
Pulse width
→  93
Failure mode
→  93