Entrust Datacard CR825 - 127: Emboss Transport Error; 128: Embosser Card Jam; 129: Embosser Topper Jam; 130: Embosser Card Entry Jam

CR825 and CE875 Instant Issuance System User’s Guide 85
127: Emboss transport error
The card is not correctly positioned in the embosser.
1. Open the embosser and remove the supply cartridges.
2. Remove any cards found.
3. Replace the cartridges, close and lock the embosser.
128: Embosser card jam
The card path is blocked in the embosser.
1. Open the embosser and remove the supply cartridges.
2. Remove any cards found.
3. Replace the cartridges, and then close and lock the embosser.
HINTS & TIPS
Refer to “Clear an Embosser Card Jam” on page A-10 for more information.
129: Embosser topper jam
The embosser topping foil is not moving properly.
1. Open the embosser and remove the topping foil cartridge.
2. Reposition, repair, or replace the topping foil.
3. Replace the cartridge, and then close and lock the embosser.
130: Embosser card entry jam
The card path is blocked in the embosser.
1. Open the embosser and remove the supply cartridges.
2. Remove any cards found.
3. Replace the cartridges, and then close and lock the embosser.
HINTS & TIPS
Refer to “Clear an Embosser Card Jam” on page A-10 for more information.