88 Troubleshooting
141: Close emboss cover
The embosser, printer, or multi-card hopper is open.
Make sure that all access doors are closed securely and locked.
142: Emboss cover error
The embosser, printer, or multi-card hopper is open.
Make sure that all access doors are closed securely and locked.
143: Topping foil problem
The embosser topping foil is not moving properly. The card will be canceled.
1. Open the embosser and remove the topping foil cartridge.
2. Reposition, repair, or replace the topping foil and advance the repaired area one full turn.
3. Replace the cartridge, and then close and lock the embosser.
HINTS & TIPS
Refer to “Load the Topping Foil Cartridge” on page A-8 or to “Repair Broken Indent Ribbon or
Topping Foil” on page A-11 for more information.
144: Topping foil out
The embosser does not have usable topping foil.
1. Open the embosser and remove the topping foil cartridge.
2. Install new topping foil.
3. Replace the cartridge, and then close and lock the embosser.
HINTS & TIPS
Refer to “Load the Topping Foil Cartridge” on page A-8 for more information.
145: Topping foil type problem
The embosser cannot use the topping foil installed. The card will be canceled.
Use supplies designed for this printer.
146: Topping foil support err
The embosser cannot use the topping foil installed. The card will be canceled.
Use supplies designed for this printer.
To Next Page
Loading...
