86 Troubleshooting
131: Embosser card exit jam
The card path is blocked in the embosser.
1. Open the embosser and remove the supply cartridges.
2. Remove any cards found.
3. Replace the cartridges, and then close and lock the embosser.
HINTS & TIPS
Refer to “Clear an Embosser Card Jam” on page A-10 for more information.
132: Embosser card stack full
The embosser output hopper is full or blocked.
Remove cards from the output hopper.
133: Embosser card reject full
The embosser reject tray is full.
1. Open the embosser and empty the reject tray.
2. Close and lock the embosser.
HINTS & TIPS
The embosser reject tray holds five cards. Empty it regularly to avoid receiving the message.
Refer to “Empty the Embosser Reject Tray” on page A-9 for more information.
135: Indent ribbon supplies out
The embosser does not have usable indent ribbon.
1. Open the embosser and remove the indent ribbon cartridge.
2. Install a new indent ribbon.
3. Replace the cartridge, and then close and lock the embosser.
HINTS & TIPS
Refer to “Load the Indent Ribbon Cartridge” on page A-6 for more information.
To Next Page
Loading...
