CR825 and CE875 Instant Issuance System User’s Guide 79
171: Insert same card side 1 up
1. Take the card from the printer and turn it over end to end so side 1 is facing up.
2. Insert the card in the printer.
3. If the card is not immediately picked, press the printer’s User button.
172: Insert cleaning card
1. Insert cleaning card.
2. If the card is not immediately picked, press the printer’s USER button.
173: Improper shutdown
Always use the POWER button to power off the printer.
Press and hold the U
SER button to set the printer to Ready.
Click OK on the PC to clear the message.
HINTS & TIPS
The system was shut down incorrectly or lost power.
175: C2 supply error
The C2 retransfer film has encountered an error.
1. Open the printer access door and remove the C2 retransfer film cartridge.
2. Reposition, repair, or replace the supply and advance the repaired area one full turn.
3. Replace the C2 retransfer film cartridge.
4. Close the printer access door.
Press the U
SER button on the printer to clear the message.
HINTS & TIPS
Refer to “Replace the Retransfer Film” on page 37 or “Repair a Broken Ink Ribbon or Retransfer
Film” on page 67 for more information.
176: C2 supply type error
The C2 retransfer film does not support an action requested by this print job.
Use a supply designed for this printer model.
Press the U
SER button on the printer to clear the message.
To Next Page
Loading...
