EPRAD eCNA-10 - RDI Server Status Message Details

204 pages

Save Page as PDF

To Next Page

To Previous Page

The Resp checkbox should be unchecked for all Christie commands unless the FYI and Error

message broadcast is enabled. The eCNA does not enable or disable these messages.

156

eCNA-10 Operation and Installation Manual Version 1.270-00

Main Page

Table of Contents5
Product Description9
Control Panel10
Display Screen11
Power up Screen11
Top Level Screens12
Run Status Screen12
Output Screen13
Menu Screens13
Network Status Screen13
Ethernet TCP/IP Screens15
User-Defined Keys Screen16
Dimmer Screens16
Information Screen17
Status and Fault Messages17
Configuring the Unit19
Configuring the Main CPU Board19
Configuring Ethernet Via the Serial Port23
Configuring Via the Web Browser26
Setup27
Setup: Ethernet Network27
Setup: Wake-On-LAN29
Setup: Triggers30
Setup: Fault Behavior33
Setup: Real Time Clock35
Setup: System Parameters36
Setup: Segment Names41
Setup: Output Flag Names42
Setup: Input Flag Names43
Setup: CAI Sendfx Names44
Setup: User Key Names45
Setup: Timer Names46
Setup: Remote Devices47
Setup: Clock Events51
Setup: Virtual I/O52
I/O Boards54
Setup: 39431/39445 House/Aux55
Setup: Light Control59
Setup: Zone Names59
Setup: QDC-400 Dimmer Boards60
Setup: RVC-5 Card61
Voltage Monitor62
Administration63
Setup: Backup Ecna-10 Configuration63
Setup: Restore Ecna-10 Configuration64
Setup: Device Firmware Update65
Programs67
Program and Macro Instructions67
Setup: Program Editor82
Setup: Macro Editor83
Status84
Status: Main Status84
Status and Fault Messages85
Status: Network Monitor86
Status: Local I/O Network88
Status: Ethernet Network90
Status: Event Log90
Status: System Control Detail91
Status: I/O Flag Detail92
Status: CAI/RDI Messages93
Status: Light Control93
Status: Management Data94
Status: CIA Configuration Detail95
CAI Serial Commands96
EVENT Command98
LOG Command99
CONFIGURATION Command100
STATUS Command101
OUTPUT Command103
READ CLOCK Command105
SET CLOCK Command106
REPORT ID Command107
EXCHANGE STATUS Command108
REPORT STATUS Command112
STATUS/CONTROL MESSAGE WRITE Command114
STATUS/CONTROL MESSAGE READ Command115
EVENT Report116
EVENT Log118
EVENT Status/Control Message127
Error Response Numbers128
Connect Error Response128
Checksum129
Command Summary130
Event Report Summary133
Event Log Summary135
System Block Diagram140
I/O Termination Board144
39445 House/Aux Termination Board144
39445 Termination Schedule146
39445 Board Dimensions149
39431 House/Aux Termination Board150
39431 Termination Schedule152
39431 Board Dimensions154
Termination Board Inputs155
Termination Board Outputs157
Power Supply158
Appendix A: Remote Device Support159
NEC ® Digital Cinema Projectors159
Barco Digital Cinema Projectors161
Christie Digital Cinema Projectors163
Dolby CP650 Digital Cinema Processor165
Appendix B: Status/Control Message Table166
Cinema Automation Interface (CAI) Client Status/Control Messages166
Remote Device Interface (RDI) Server Status Messages167
Appendix C: LVM-250 Line Voltage Monitor Examples169
Appendix D: Digital Cinema Server Setup174
GDC Technology SA-2100A174
Doremi DCP-2000184
Appendix E: RS-232 Adapter Board Installation194
Appendix F: Firmware Revision History195

EPRAD eCNA-10 - RDI Server Status Message Details

Table of Contents