© EPRAD Incorporated
4.3.18 Setup: 39431/39445 House/Aux
Click on 39431/39445 House/Aux under I/O Boards from the Setup Menu. This screen is used to
setup the board’s outputs and inputs.
Relay control can be changed by using the Controlled by column in the Outputs table. A relay can
be controlled by any of the output control flags in the list box.
Aux Out 1 through 5 are on the House/Aux board, while Aux Out X1 through X8 are on the optional
39436 Aux I/O board. Use the list box to select the output control flag to assign to the relay.
Any relay can be configured for Pulsed or Maintained Contacts or Invert. Click on the Reset
button to put the original data back. Click the Submit button to save new settings to the eCNA-10.
47
eCNA-10 Operation and Installation Manual Version 1.270-00
To Next Page
Loading...