© EPRAD Incorporated
4.3.8 Setup: Segment Names
Click on Segment Names under General in the Setup Menu. This screen displays the Segment
Names.
Segment names can be used to identify parts of a presentation. For example, a typical show could be
divided into Pre-show, Previews, Feature, Credits and Between Shows segments. Use the Segment
instruction in a program or a macro along with any other instructions that set up the auditorium for
that particular show segment. The segment name will be displayed on the eCNA status screens and
are available to the CAI client with the XST, RST and STS commands.
The names can be edited with up to 14 text characters. Click inside the text box and type the name.
All characters are supported except:
double quote “ less than < ampersand &
single quote ‘ greater than > open bracket [
semi-colon ; backslash \ close bracket ]
Click the Submit button to save new names to the eCNA-10. The Reset button puts the original data
back.
33
eCNA-10 Operation and Installation Manual Version 1.270-00
To Next Page
Loading...