© EPRAD Incorporated
Error Timer This is the number of seconds that the LIN device has not responded.
Inputs This string of digits represent the actual state of the inputs. A “1" represents an input that is
present. A “0" represents an input that is not present.
House/Aux Board Inputs
Outputs This string of digits represent the actual state of the relay outputs. A ‘1' represents an
output that is on. A ‘0' represents an output that is off.
House/Aux Board Outputs
Attribute The attribute bits indicate the state of any configuration DIP switches and jumpers.
Status These messages are displayed based on internal status flags.
Device Active
Exchanging I/O
Setup Parameters Received
Id & Device Type Received
Wrong Device Type
Communications Link Error
Not Responding Regularly
81
eCNA-10 Operation and Installation Manual Version 1.270-00
To Next Page
Loading...