Epson RC180 - Page 221

Maintenance 8. Trouble Shooting
RC180 Rev.17 209
No.
Message
Remedy
Note 1
Note 2
3259
Network communication port number
was not specified.
Network communication port number is
not specified in ChkNet function. Refer
to SPEL+ Language Reference “ChkNet
Function”
and specify a proper port
number.
3260 Language ID was not specified.
Language ID is not specified in
ErrMsg$ function. Refer to SPEL+
Language Reference
“ErrMsg$ Function”
and specify a
proper language ID.
3261
Expected '.'.
Add '.'.
3262
Vision Sequence Name was not
specified.
Vision sequence name is not specified in
Vision Guide commands such as VSet,
VGet, and VRun. Add a sequence
name.
3263
Vision Sequence Name or Calibration
Name was not specified.
Vision sequence name or calibration
name is not specified in VSet and VGet
statements. Add a sequence name or
calibration name.
3264
Vision Property Name or Result Name
was not specified.
Vision property name or result name is
not specified in VSet and VGet
statements. Add a property name or
result name.
3265
Vision Property Name, Result Name
or Object Name was not specified.
Either of Vision property name, result
name, or object name is not specified in
VSet and VGet statements. Add either
of a property name, result name, or
object name.
3266
Vision Calibration Property Name was
not specified.
Vision calibration property name is not
specified in VSet and VGet statements.
Add a property name.
3267 Task type was not specified.
Task type is not specified in Xqt
statement. Refer to
SPEL+ Language
Reference “Xqt Statement” and specify a
proper task type.
3268 Form name was not specified.
Form name is not specified in GSet,
GGet, GShow, GShowDialog
, and
GClose statements. Specify a form
name.
3269
Property Name or Control Name was
not specified.
P
roperty name or control name is not
specified in GSet and GGet statements.
Specify a property name or control name.
3270 Property Name was not specified.
Property name is not specified in GSet
and GGet statements. Specify a
property name.
3271 BackColorMode was not specified.
BackColorMode property setting value is
not specified in GSet statement. Refer
to GUI Builder 5.0 manual
“BackColorMode Property” and specify
a proper setting value.
3272 BorderStyle was not specified.
BorderStyle property setting value is not
specified in GSet statement. Refer to
GUI Builder 5.0 manual “BorderStyle
Property” and specify a proper setting
value.