Epson RC180 - Page 222

Maintenance 8. Trouble Shooting
RC180 Rev.17
210
No. Message Remedy Note 1 Note 2
3273 DropDownStyle was not specified.
DropDownStyle property setting value is
not specified in GSet statement. Refer
to GUI Builder 5.0 manual
“DropDownStyle Property” and specify a
proper setting value.
3274 EventTaskType was not specified.
EventTaskType property setting value is
not specified in GSet statement. Refer
to GUI Builder 5.0 manual
“EventTaskType Property” and specify a
proper setting value.
3275 ImageAlign was not specified.
ImageAlign property setting value is not
specified in GSet statement. Refer to
GUI Builder 5.0 manual “ImageAlign
Property” and specify a proper setting
value.
3276 IOType was not specified.
IOType property setting value is not
specified in GSet statement. Refer to
GUI Builder 5.0 manual “IOType
Property” and specify a proper setting
value.
3277 FormBorderStyle was not specified.
FormBorderStyle property setting value
is not specified in GSet statement.
Refer to GUI Builder 5.0 manual
“FormBorderStyle Property” and specify
a proper setting value.
3278 ScrollBars was not specified.
ScrollBars property setting value is not
specified in GSet statement. Refer to
GUI Builder 5.0 manual “ScrollBars
Property” and specify a proper setting
value.
3279 SizeMode was not specified.
SizeMode property setting value is not
specified in GSet statement. Refer to
GUI Builder 5.0 manual “SizeMode
Property” and specify a proper setting
value.
3280 StartPosition was not specified.
StartPosition property setting value is not
specified in GSet statement. Refer to
GUI Builder 5.0 manual “StartPosition
Property” and specify a proper setting
value.
3281 TextAlign was not specified.
TextAlign
property setting value is not
specified in GSet statement.
This error occurs when the control type
cannot be identified because the control
is specified by a string variable. Refer
to GUI Builder 5.0 manual “TextAlign
Property” and specify a proper setting
value.
3282 TextAlign was not specified.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control is a
text box. Refer to GUI Builder 5.0
manual “TextAlign Property” and specify
a proper setting value.