Epson RC180 - Page 227

Maintenance 8. Trouble Shooting
RC180 Rev.17 215
No.
Message
Remedy
Note 1
Note 2
3810
The number of point file is beyond the
limit.
There are too many point files.
Reduce some point files that are
registered to project.
3811
The number of points is beyond the
limit.
There are too many points defined by
registered point files.
Reduce some points.
3850
File not found.
3900
Uncommon error. Cannot obtain the
internal communication buffer.
3901
Buffer size is not enough.
3910
Undefined command was specified.
3911
Cannot enter the file name in the file
name buffer.
3912
Cannot obtain the internal buffer.
3913
Cannot set priority. Reboot the controller.
3914 Invalid ICode.
Rebuild the project.
3915 Invalid ICode.
Rebuild the project.
3916 Invalid ICode.
Rebuild the project.
3917 Invalid ICode.
Rebuild the project.
3918 Invalid ICode.
Rebuild the project.
3919 Invalid ICode.
Rebuild the project.
3920 Invalid ICode.
Rebuild the project.
3921 Invalid ICode. Rebuild the project.