Epson SC-F2000 - Page 189

SC-F2000 Revision C
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 189
Confidential
3.4.7.2 BOARD BOX FAN 2
1. Remove the PRINTER COVER. (p72)
2. Remove the RIGHT HOUSING PLATE. (p74)
3. Remove the RIGHT COVER ASSY. (p88)
4. Remove the LEFT HOUSING PLATE. (p73)
5. Remove the LEFT COVER ASSY. (p86)
6. Remove the REAR COVER SUB ASSY. (p77)
7. Remove the REAR COVER. (p79)
8. Remove the SUB-B BOARD. (p98)
9. Remove the MAIN BOARD. (p95)
10. Disconnect the cable from the connector (CN11) of the MAIN BOARD.
11. Remove the two screws, and remove the BOARD BOX FAN 2.
A) Silver M3x14 Bind machine screw: 2 pcs
Figure 3-155. Removing the BOARD BOX FAN 2
Install the BOARD BOX FAN 2 so that the Label comes to the
inside. (See Figure 3-155)
BOARD BOX FAN 2
A
A