EasyManuals Logo

Essilor Neksia User Manual

Essilor Neksia
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Place the pattern holder in the tracing table
Insert the front tab of the support between the white cylindrical studs of the tracing table.
Block the back tab of the support.
Adjust the jaws of the tracing table so as to block the pattern holder.
Start the cycle.
Release the pressure on the white circles so the rear tab goes into the slit located opposite the cylindrical
white pins (next to you - see illustration below).
Check that the pattern holder does not move in the table.
Tracing
Press to start mechanical tracing.
To interrupt tracing at any time, press .
The tracer automatically detects the pattern holder.
Neksia > v1-02-14
34
USER MANUAL> II. TRACING
>
1
2
3
4
5
1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Essilor Neksia and is the answer not in the manual?

Essilor Neksia Specifications

General IconGeneral
BrandEssilor
ModelNeksia
CategoryEdger
LanguageEnglish

Related product manuals