Euphonix Max Air - Filters; Filters Knobsets

Euphonix Max Air Mixing Console Operation Manual Channels and Strips
103
Filters5.3.4
Each channel has two lters with four lter types available: high-pass lter, low-pass
lter, band-pass lter and a notch lter. Press the Filt Knobset Select key to display the
Filter controls on the knobs.
On
On
On
On
Select
Select
Select
Select
Copy Paste
F1tp
F1Q
F1fr
Page 1
Filter 1 in/out
Listen
On
On
On
On
Select
Select
Select
Select
Copy Paste
F2tp
F2Q
F2fr
Page 2
Filter 2 in/out
Listen
Filters knobsetsFigure 5-12
Filter Type (F1tp, F2tp): Select from four lter types low-pass lter (LPF), high-pass
lter (HPF), band-pass lter (BPF), and notch lter (NTCH). The lower key to the left
of the lter type knob switches each lter in/out.
Filter Q (F1Q, F2Q): The band-pass and notch lters have a variable Q from 0.2 to 12.
This function has no effect on high- or low-pass lter types.
Filter Frequency (F1fr, F2fr): The frequency range is 20.5 Hz to 21 kHz.
Listen: To help nd problematic frequencies, the Notch lter can be put into a bandpass
mode by pressing the Listen key to the lower left of the Filter Frequency knob. The boost
setting is not saved in the Title and defaults to Off.