Euphonix Max Air Mixing Console Operations Manual Quickstart to Common Tasks
30
Label Individual Signals3.2.3
From the Patch view:
Select the 1. Sources tab.
Select 2. Mic Line 1 from the list on the left.
Select 3. Rename Port and enter Mic 1-24 using the keyboard popup.
This enters meaningful names into each of the 24 mic input name slots.
Each mic can now be individually named. Touch the rst beige box in the 4. Name
column that shows Mic 1-24-1. Use the keyboard popup to rename it Mic 1 and
hit the “Enter” key. You can use the hardware keyboard’s down arrow to tab to the
next name eld.
Touch the gray 5. Analog 1-24 button (the second gray button from the top-left,
originally labeled Frame 1-2).
The names in the beige Name list can now be changed to reect the actual sources 6.
connected to these 24 analog inputs (e.g. VTRA1, VTRA2, TEL1, etc.).
Touch the gray 7. Digital In 1 gray button (the third from top-left) to rename the in-
dividual digital inputs from the third MADI port. Do the same for the fourth Hub
input we earlier named Digital In 2.
Label Destination Ports and Signals3.2.4
Select the Destinations tab to name the output MADI ports and their individual sig-
nals. Their names will depend on how these MADI ports are connected to the outside
world. In the system diagram (Figure 1-1), four ports are shown. One of these ports is
always used for the monitor outputs that connect to the MC524 Monitor Interface so
only three ports appear in the destinations list as Frame1-1, Frame1-2, Frame1-3. In the
above example, Frame1-1 is connected to 24 analog outputs, the other two to 56-channel
digital format converters. Rename the Frame1-1, Frame1-2, Frame1-3 ports and their
individual signals.
To Next Page
Loading...
Need help?
General
