Euphonix Max Air - 6.3 Configuring Aux Busses

Euphonix Max Air Mixing Console Operation Manual Busses
114
Format SelectorFigure 6-3
The possible formats are:
none (remove a format from a bus)
mono (M)
stereo (L, R)
LCRS (L, C, R, S)
5.1 (L, C, R, SL, SR, B)
6.1 (L, C, R, SL, SR, SC, B)
7.1 (L, LC, C, RC, R, SL, SC, SR, B)
Touch the 3. Set Format button when the desired format appears.
If the number of bus cells selected is less than the number of channels in the format, the
rst channels in the format are used. For example, if two bus cells are selected and the
LCRS format is selected, the two lower numbered cell receives LCRS L and the higher
numbered cell receives LCRS C.
It is also possible to set busses to a format and then reformat some of those busses to
None. For example, if four busses receive the LCRS format, three could be selected and
set to None, leaving just LCRS S.
If there are more selected bus cells than channels in the format, the rst channels are
re-used for the additional cells, For example, if six bus cells are selected and the LCRS
format is selected, the rst four cells are labeled as expected (LCRS), but the last two are
LCRS L and LCRS C.