Euphonix Max Air Mixing Console Operation Manual Channels and Strips
96
Channel On Select Key
The Select key is used to include the channel On key in copy and clear operations.
Channel Select Key5.2.7
The Chan Select key is used:
to include the entire channel in a copy or clear operation.•
in conjunction with the • Wave key to assign channels (page 92).
Solo Key5.2.8
The Solo key is used to solo the active channel (page 142).
Copy and Paste5.2.9
Settings from one channel may be copied and pasted to others.
To copy the settings:
Press and hold the 1. Wave key down and press the Copy key.
The strip dims and the Copy key ashes.
Press the 2. Chan Select key to select the entire channel, or press any Knobset Select
key at the top of the strip to copy that function to the copy buffer. Other functions
can be added to the buffer by pressing their Knobset Select keys.
Press and hold the 3. Wave key down and press the Copy key to stop it from ashing
and exit the mode.
To paste the settings to a new channel:
Select the Swap or Main channel within the desired strip.1.
Press and hold the 2. Wave key down and press the Paste key on the new channel.
The buffered information is pasted to the channel on the new strip.
Rotary Knobs5.2.10
Each strip has four rotary knobs each with a four-character display and two keys. The
knob is a continuous controller; as the knob turns, the LEDs on the outer ring light. The
display shows the knob’s current function or parameter value.
The lower key to the left of the knob toggles the knob’s function • In/Out.
The upper key to the left of the knob is the • Select key for the In/Out key below
it. This key is also used to select the On/Off key for inclusion in a Snapshot and
To Next Page
Loading...
