Euphonix Max Air Mixing Console Operation Manual Channels and Strips
95
Backstop PFL
The Max Air faders have a backstop key past the bottom of their travel. Pull a fader back
to route the channel’s PFL signal to the solo bus. Releasing the fader cancels that fader’s
routing to the solo bus. Backstop PFL can be used on group masters to solo a control
group. See page 145 for more information.
Meters5.2.3
The meter can show the active channel, or Main and Swap, and can also show gain
reduction in the bottom four LEDs on the right meter (see Meters on page 83). Stereo
channels display the left and right channels on the left and right sides of the meter, re-
spectively.
Status LEDs5.2.4
The following explanations pertain to the LED being illuminated.
48 V• : phantom power is on for the mic preamp of the active channel.
Phase• : phase is inverted for the active channel.
Lock• : strip is locked (page 77).
ST• : active channel is stereo (page 154).
Mix Minus• : mix minus key is pressed (page 110).
Fader Touch Sensor LED• : fader is being touched.
M• : active channel is Group or Multi Format Master (Chapter 8: Control Groups
and Multi Format Masters).
S• : active channel is a slave to a Group or Multi Format Master (Chapter 8: Control
Groups and Multi Format Masters).
L• : reserved for future use
Wave Key5.2.5
Pressing the Wave key has two functions:
brings the channel to the center Super Channel (see page 128).•
modies other keys like a shift key.•
Channel On Key5.2.6
The On key turns the channel on and off.
To Next Page
Loading...
