Euphonix Max Air - Route to the Main Sections and Busses; Using the 24 Group Busses

Euphonix Max Air Mixing Console Operations Manual Quickstart to Common Tasks
36
Route to the Main Sections and Busses3.4.2
Route Channels
Press 1. All key on center section just below the left of the screen.
Press the 2. Main button at the top of any strip to select Main section routing on all
strips.
The ◄► keys at the bottom of the knobsets allow paging if there are more than four
Main sections.In this case the Prog (Main section E) appears on the 2nd page.
The four Main sections are shown as SubA, SubB, SubC and SubD in each Strip. 3.
To route the channel to SubA, press the On key next to the knob labeled SubA.
The routing LED at the top of the Strip shows the channel is routed to Main section
A. Do this for the rst 16 Strips.
Press any Strip’s 4. Swap button and repeat steps 2 and 3 so that the backup mics
plugged into channels 17–32 are also routed to Main section A.
Using the 24 Group Busses3.4.3
Max Air includes up to 24 Group busses. These are very useful for additional clean feeds
or extra stereo outputs. As an example we could use Groups 1 and 2 as a stereo foldback
output.
Select 1. Busses from the Main Menu and the Group tab.
Check that 1 and 2 are set to stereo. If not select the stereo format from the Format 2.
Selector, select busses 1 and 2, and press the Set Format button.
For mono mix minus, these could be set as mono busses.
To route a channel to these busses, press the 3. Group button at the top of a Strip. The
group pairs show next to the four knobsets.
Press the two buttons below the 1/2 group display next to the top to route the chan-4.
nel to these busses.
The routing LEDS at the top of the channel light to show routing to Groups 1 and
2.
The output level of the groups can be brought up on the Soft Knobs below the 5.
screen by pressing the Group Bus Masters button on the surface just below the
right edge of the Touchscreen.