Euphonix Max Air Mixing Console Operations Manual Quickstart to Common Tasks
35
Placing Main Busses on the Center Section (CM404)
Press the 1. Surface button on the right side of the touch screen and select the “as-
sign” tab. In the upper block, select the Main Sections tab to display the Main/
Mix busses. Select Sections A through E and in the lower Strip block, select the
Center tab. Touch the button representing Center Strip 1 and Main Sections A
through E will be displayed on the rst ve center faders.
Press the 2. Super Channel button on the right side of the touch screen to bring up
the Super Channel page.
On Main Section “A” (SubA), press the 3. Wave key (blue Euphonix logo next to the
fader) in order to display that channel’s parameters and assignments on the Super
Channel.
In the upper left corner of the Super Channel display, press the 4. Setup button in
the Group/Main/Aux assignment box. A pop-up window appears allowing you to
assign that Main (SubA) section to the PGM Section “E”. Take care to not assign
a section to itself: e.g. do not route Main Section A to Main Section A, as feedback
will result.
Figure 3-2
Once SubA is assigned to PGM, press the wave key on the fader representing 5.
SubB. The assignment pop-up stays open, but now reects SubB’s routing As-
sign SubB to PGM. Repeat this process for the two remaining sections (SubC and
SubD) and close the assignment pop-up window.
You have now routed your four Sub Sections A-D to the PGM output bus E.6.
Depending on your Mixer Model, it may be desirable to add buss processing (com-7.
pression and limiting) to the output bus and sub sections. Please refer to Chapter
6, pages 111-125 for details on assigning processing to busses.
To Next Page
Loading...
