Euphonix Max Air - Page 178

Euphonix Max Air Mixing Console Operation Manual Event System
178
To achieve this, several programming steps are involved:
A separate Snapshot must be created for each camera fader’s on and off position.1.
A separate Scene must be created for each Snapshot. This enables the user to enter 2.
a glide time.
A separate Event must be created for each of the GPIs to be used, one for logic 3.
“High” state and one for logic “Low.” Each GPI state will trigger a different
Scene.
The following describes the logic ow (Camera 1 only):
Camera 1 Take → GP132 GPI 1 logic “High” → Event 1→Scene 1 (with glide 1.
time)→Snapshot 1 (Cam 1 fader up)
Camera 1 UnTake → GP132 GPI 1 logic “Low” → Event 2→ Scene 2 (with glide 2.
time)→ Snapshot 2 (Cam 2 fader down)
The following procedure enables audio-follow-video for Camera 1. Repeat using differ-
ent events, scenes, and snapshots to enable additional cameras.
Store Snapshot 1 with the following: Channel 1 fader at 0dB.1.
Store Snapshot 2 with the following: Channel 1 fader at -∞2.
Create Scene 1 with the following:3.
Name Ch 1 UP
ID (1)
Glide Time (S): 1.00 sec
Snapshot # 1
Auto Follow off
Auto Follow Time 2.00 sec
Create Scene 2 with the following:4.
Name Ch 1 Down
ID (2)
Glide Time (S): 1.00 sec
Snapshot # 2
Auto Follow off
Auto Follow Time 2.00 sec