EverFocus NVR - Restart the Unit; Shutdown the Unit

62
4. Check the Adjust clock for daylight saving changes option and select
the time change of daylight saving time in your location.
5. Click the OK button.
2.7.8 Restart the Unit
1. Open Internet Explorer and log in to the unit.
2. Click System / Reboot/Shutdown.
3. Check the Reboot option.
4. Click the OK button.
5. A confirmation dialog pops up. Click the OK button to reboot the unit.
The restart procedure runs automatically. When the unit is fully online:
 The System Status LED turns blue.
 The buzzer beeps one time (if the buzzer is enabled).
During system restart, none of your files will be accessible from your
desktops/laptops.
2.7.9 Shut Down the Unit
The only time you need to shut down the unit is to replace the disk drive
cooling fan or the power supply. During and after the shutdown, none of your
files will be accessible from your desktops/laptops. There are two ways to
shutdown the unit.
 Shutdown by Software
1. Open Internet Explorer and log in to the unit.
2. Click System / Reboot / Shutdown.