Evoqua DEPOLOX - Page 60

60 WT.050.570.000.DE.IM.0714
Operation DEPOLOX
®
Pool
1.3
Analog out  mA 1 ... 4 
 mA signal  0 ... 20 mA / 4 ... 20 mA
NOTE
mA 1: Not available when Cl
2
control output set to "analog output"
(Display 1.1.1)
mA 2: Not available when pH control output on "analog output"
(Display 1.2.1)
mA 3: Not available when conductivity control output on "analog
output"
(Display 1.5.1)
Digital input
 DI (2) / DI (3)  Each digital output can be assigned a
parameter with the softkey "SELECT"
 CONTROLLER STOP  Yout = 0 %, positioner closed, pumps off,
mA analog output = 0 %
 CONTROLLER CONST Yout remains constant, i.e. the control
signals are kept constant
 MA CONSTANT  All mA outputs remain unchanged.
 CHANGEOVER MODE When DI is activated, changeover from
Automatic to Manual, positioner constant,
pump off, mA analog output= 0 %
 ECONOMIC  When DI is activated, the ECO
parameters are used for chlorine and
flocculation
control
Interface
 RS232 
 RS485 address  Bus addresses 00 ... 31
 CAN segment  Segment address of the CAN bus, 0...63
External functions
(Release external
control functions)
 Flocculation  Off / On
 DIN 19643 funct.  Release contact when DIN values
are met, e.g. for decreasing circulation
Off / On)
 Cl
2
 pH
 mV
 Cl-N
 Conductivity
 °C
 Ym / Yout Cl
2
 Off
 Printer
 IAP-Download
 Off