Maintenance
136 OX1
Replacing the Click-Out Optical Connector (Pro Models Only)
To replace (or reinstall) the Click-Out optical connector:
1. Position the new Click-Out connector vertically so that you can see its
release tab and that the optical port is pointing upwards.
2. Remove the dust cap protecting the optical connector (which should
be pointing downwards), being careful not to touch the optical
connector.
3. Inspect the optical connector (from which you have just removed the
dust cap), and clean it if necessary.
Optical port
Optical connector with
dust cap
Release tab
To Next Page
Loading...
