Troubleshooting
Optical Xplorer 171
Restoring Your Unit to Normal Operation
Restoring Your Unit to Normal Operation
If you ever encounter major problems with your unit (for example, the unit
does not behave the way it used to), you can revert it to its initial state (as it
was at time of purchase).
For current updates, use the update tool provided with your unit
(see Upgrading Applications and Firmware on page 163).
CAUTION
Once the recovery operation is started, it cannot be cancelled.
Follow the procedure below carefully and connect your unit to a
power outlet using the provided USB power adapter when you
are instructed to do so.
CAUTION
Electrostatic discharge (ESD) damage can cause complete or
intermittent equipment failures.
Always use an ESD-preventive wrist or ankle strap when
opening your unit. Ensure that the antistatic strap makes good
skin contact and that the end of its wire is grounded properly.
Never touch any component inside the unit other than those
identified in the procedure hereafter, either with tools or your
fingers.
To Next Page
Loading...
Need help?
General
