Getting Started with Your Unit
Optical Xplorer 23
Turning off Your Unit
Turning off Your Unit
Unless specified otherwise in this documentation, the settings you
configure on your unit are kept in memory even when you turn the unit off.
There are several ways to turn off the unit, including the following:
Sleep: keeps the unit’s status information in memory (RAM). The next
time you turn your unit on, you will quickly return to your work
environment (running applications will still be running). If you intend
to leave your unit in sleep mode for more than a few hours, you should
perform a shutdown instead to save battery power. After four hours in
sleep mode, your unit will go into shutdown mode automatically to
save battery power.
Shutdown: completely cuts power to the unit; the unit will perform a
complete restart routine the next time you use it.You should perform a
shutdown if you do not intend to use your unit for several hours.
After a shutdown, the unit will start in Fiber Xplorer.
Note: Should the unit ever stop responding, you can force a hardware reset by
pressing and holding down the on/off button for at least 10 seconds. To
restart your unit, release the on/off button, and then press it again as you
would normally do to start your unit.
To enter the sleep mode:
Press the on/off button. The unit’s backlight will turn off and the
touchscreen will be deactivated.
To exit the sleep mode and resume your work:
Press the on/off button.
To turn off the unit completely (shutdown):
Press the on/off button for about three seconds. The unit will beep once
and its LED will light up briefly.
To Next Page
Loading...
Need help?
General
